Go Back   ChevyXtreme Classic Chevrolet Enthusiast Forum & Web Link Directory > Chevrolet Tech Board {CLICK HERE TO SEE ALL GROUPS WITH CURRENT THREADS} > Engine & Drivetrain

Thread Tools Display Modes
Old 01-05-2017, 01:12 AM   #1
Respected Member

mjgord51's Avatar
Join Date: Apr 2016
Posts: 199
My Mood:
mjgord51 is on a distinguished road
Center CrossMember at Support Bearing ??'s

I have a 68 C10 LWB Fleetside Truck that I want to Lower 4"s (coil springs) in the rear but I am wondering if I have a One piece Alum. Driveshaft made will the lowering effect the center cross member hole where the shaft passes through being the new drive shaft will now be 4" instead of the original 3" shaft by coming too close to the cross member sides, will it need to be cut more bigger for the new larger 4" Driveshaft? Any help or "Link" suggestions will be appreciated very much. Thanks, Marvin
A. Resting up on Mon-Fri from Sat & Sun

B. Swallow Pride and get Answers Needed

C. My definition for a Retired Person is-If I want, When I want, and If at all I want
mjgord51 is offline   Reply With Quote

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2018, vBulletin Solutions, Inc.
Content And Images Copyright © 67-72Chevyboard.com